Figure 44. Installing the drive cage
Next steps
1. Install the drive backplane.
2. Install all the drives.
3. Follow the procedure listed in After working inside your system.
Control panel
Removing the control panel
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove all the drives.
4. Remove the drive cage.
Steps
1. Releasing the blue latches, pull the blue strap to disconnect the control panel cable connected to the system board.
2. Using the Phillips #1 screwdriver, remove the screws that secure the control panel to the system.
3. Holding the control panel, remove the control panel along with the cable from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components 49
To Next Page
Loading...
