Table 29. Mezzanine card riser configurations (continued)
Mezzanine card category Description Slot priority Maximum cards
(Fl)
QLogic QME2742 (FC32 DP) Mezzanine slot C (mini-Mezz
slot)
1
Storage PERC 9: HBA330 MMZ Mezzanine slot C (mini-Mezz
slot)
1
PERC 10: H745P MX V3 Mezzanine slot C (mini-Mezz
slot)
1
PERC 11: HBA350i PERC connector 1
PERC 11: H755 MX PERC connector 1
Removing the Mezzanine card
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Use the Phillips #2 screwdriver, loosen the captive screws that secure the Mezzanine card to the system.
2. Lift the Mezzanine card out of the sled.
NOTE: To prevent damage to Mezzanine card, you must hold the card only by its edges.
Figure 76. Removing the Mezzanine-A card
82
Installing and removing system components
To Next Page
Loading...
