Dell EMC PowerEdge MX750c - Removing the Mini Mezzanine Card; Installing the Mini Mezzanine Card

Removing the mini Mezzanine card
Prerequisites
CAUTION: To ensure proper system cooling, mini Mezzanine blank must be installed in the mini Mezzanine
socket.
NOTE: It is recommended to remove the mini Mezzanine blank only if you intend to install mini Mezzanine card in the
sockets.
1. Follow the safety guidelines listed in Safety Instructions.
2. Follow the procedure listed in Before working inside your system.
NOTE: MX750c supports HBA330 MMZ and Fiber channel MMZ, which is installed in mini Mezzanine socket.
Steps
1. Pull the blue pull tag to lift the lever up of the mini Mezzanine card.
2. Holding the lever and the edge of the mini Mezzanine card, lift the mini Mezzanine card from the system.
Figure 80. Removing the mini Mezzanine card (HBA330 MMZ)
NOTE: Install the connector cap on the I/O connector of the mini Mezzanine card, when not installed on system board.
Next steps
1. Follow the procedure listed in After working inside your system.
Installing the mini Mezzanine card
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions.
2. Follow the procedure listed in Before working inside your system.
Installing and removing system components
85