Dell EMC PowerEdge MX750c - Installing the M.2 SSD Module

Figure 74. Removing the M.2 SSD module
Next steps
1. Replace the M.2 SSD module.
Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
1. Align the M.2 SSD module at an angle with the M.2 BOSS card connector.
2. Insert the M.2 SSD module firmly until it is fully seated in the M.2 BOSS card connector.
3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the M.2 BOSS card.
80
Installing and removing system components