Figure 68. Removing the IDSDM card
Next steps
1. Replace the IDSDM module.
Installing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
CAUTION: To prevent damage to the IDSDM card, you must hold the card only by its edges.
Steps
1. Locate the IDSDM connector on the system board.
2. Align the IDSDM card with the connector on the system board.
3. Push the IDSDM card firmly until it is fully seated on the system board.
74
Installing and removing system components
To Next Page
Loading...
