Installing the PERC card
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Pull the blue pull tag to raise the lever up on the PERC card.
2. Align the connector on the PERC card with the connector on the system board.
3. Align the guides on the PERC card with the slots on the system.
4. Press the PERC card firmly until it is fully seated.
5. Close the lever on the PERC card.
Figure 64. Installing the PERC card (HBA350i MX)
70
Installing and removing system components
To Next Page
Loading...
