PS6500 Hardware Maintenance Maintaining Control Modules
3-9
Inserting the MicroSD Card
1. Align the replacement microSD card so the arrow on the card points towards the housing (Figure 3-8).
2. Firmly press the card into the housing until it clicks into place. Make sure you cannot pull it out.
Figure 3-8: Inserting the MicroSD Card
3. Install the control module. See Installing a Control Module on page 3-6.
After you replace the micro SD card, make sure the control module is operational. See Interpreting Control Module
LEDs on page 3-1.
To Next Page
Loading...
