PS6500 Hardware Maintenance Basic Array Information
1-4
LCD Panel Display
The LCD panel, located on the array front panel behind the bezel, provides information about array hardware
status.
If the array is in standby mode, the word “standby” appears in the LCD panel.
If an array is a member of a group and there are no failures, the member name appears in the LCD panel. See
Figure 1-5.
Figure 1-5: LCD Panel – No Hardware Failures
If a hardware failure occurs, an icon and any numerical identifier for the affected component appear in the LCD
panel. See Figure 1-6.
Figure 1-6: LCD Panel – Fan Failure
If a disk drive fails, you will also see an icon showing the location of the failed drive in the chassis. See Figure 1-7.
Figure 1-7: LCD Panel – Disk Drive Failure
If multiple hardware failures occur simultaneously, the LCD panel displays multiple icons and descriptions. See
Figure 1-8.
EIP card Off Normal operation.
Flashing yellow EIP card removed.
Yellow EIP card failure.
Figure 1-4 Description (Continued)
Indicator Status Description
To Next Page
Loading...
