Index–1
Index
A
accessing field replaceable modules 1-1
array
back panel
1-6
batteries 3-1
bezel
description 1-2
installing
1-8
removing
1-8
cable management system 1-10
channel cards 5-1
control module restriction 3-6
control modules 3-1
cooling modules 4-1
cooling requirement 1-2
disk drives 2-1
EIP card 6-1
enclosure switches 1-6
environmental requirements A-1
fans 4-1
field-replaceable modules 1-1
firmware 3-3
front panel 1-2
installing bezel 1-8
installing channel cards 5-3
installing disk drives 2-7
installing EIP card 6-3
installing power supply and cooling modules 4-4
LEDs 1-2, 2-1, 3-1, 4-1
network connection guidelines 3-10
opening and closing cover 1-9
power requirements A-1
power supplies 4-1
power supply connections 4-3
powering off 1-13
powering on 1-13
protecting from discharge 1-7
removing bezel 1-8
removing channel cards 5-3
removing control modules 3-4
removing disk drives 2-4
removing EIP card 6-3
removing power supply and cooling modules 4-3
restarting 1-13
shutdown procedure 1-13
specifications A-1
B
back panel, description 1-6
batteries
charging
3-7
servicing 3-1
bezel
installing
1-9
locking 1-9
removing 1-8
unlocking 1-8
C
cable management system, using 1-10, 3-7, 4-6
cable strain relief, using 4-6
cables, network
connecting
3-7, 3-11
supported 3-11
cables, power
connecting
4-6
cables, serial
connecting
1-13
channel cards
description
5-1
handling requirements 5-3
identifying failures 5-2
installing 5-4
interpreting LED 5-1
locating 5-1
maintaining 5-1
protecting 5-3
removing 5-3
replacing 5-3
verifying operation 5-5
control modules
batteries
3-1
charging cache battery 3-7
checking proper installation 3-7
failover behavior 3-3
failure indications 3-3
firmware identification 3-3
firmware requirements 3-3, 3-7
handling requirements 3-4
LEDs 3-1
locating 3-1
microSD card
moving 3-6
replacing
3-3, 3-4, 3-7
removing 3-4
restriction on mixing 3-1, 3-6
synchronizing 3-4
types 3-1
verifying operational status 3-7
cooling
indications of failure
4-2
initialization 4-6
installing module 4-4
LEDs 4-1