Dell Force10 S4810P User Manual

Specifications | 47
8
Specifications
This chapter contains the following sections:
• Chassis Physical Design
• Environmental Parameters
• Power Requirements
• IEEE Standards
• Agency Compliance
Caution: Operate the product at an ambient temperature not higher than 113°C.
Lithium Battery Caution: There is a danger of explosion if the battery is incorrectly replaced. Replace
only with same or equivalent type. Dispose of the batteries according to the manufacturer's instructions.
Chassis Physical Design
Environmental Parameters
Parameter Specifications
Height 1.71 inches ( 43.5 mm )
Width 17.09 inches ( 434 mm)
Depth 18.11 inches (460 mm)
Weight 21.7 lbs (9.86 kg)
Parameter Specifications
Operating temperature 32° to 113°F (0° to 45°C)
Operating humidity 5 to 90% (RH), non-condensing
Storage temperature –40° to 158°F (–40° to 70°C)
Storage humidity 5 to 95% (RH), non-condensing
Maximum thermal output 1153.265 BTU/hr

Dell Force10 S4810P Specifications

General

Switching Capacity	1.28 Tbps
Forwarding Rate	952 Mpps
Manageable	Yes
Jumbo Frame Support	Yes
Jumbo Frame Size	9216 bytes
Input Voltage	100-240 VAC
Form Factor	Rack-mountable
Rack Height	1U
Power Supply	Dual, Hot-swappable
Product Type	Switch
Operating Temperature	32°F to 104°F (0°C to 40°C)
Operating Humidity	10% to 90% (non-condensing)
Latency	480 ns
MAC Address Table Size	128K entries