a. Remove the screws that secure the keyboard door [1].
b. Lift the keyboard door away from the computer [2].
c. Release the latches [3, 5] and disconnect the keyboard cables from the connectors on the system board [4, 6].
d. Lift the keyboard away from the computer [7].
Installing the keyboard
1. Connect the keyboard cables to the connectors on the system board.
2. Place the keyboard door over its slot on the computer.
3. Tighten the screws that secure the keyboard door to the computer.
4. Align the keyboard into the slot on the computer.
5. Tighten the screws to secure the keyboard to the computer.
6. Install the battery.
7. Follow the procedure in After Working Inside Your computer.
Memory modules
Removing the memory module
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base Cover
3. Pry the securing clips away from the memory module until it pops up.
4. Remove the memory module from the socket on the system board.
26
Disassembly and reassembly
To Next Page
Loading...
