4. Lift and remove the docking board from the computer chassis.
Installing the docking board
1. Connect the docking board connector cable to the system board.
2. Place the docking board on the slot.
3. Tighten the screws to secure the docking board to the computer.
4. Route the antenna cables.
5. Connect the antenna cables to the docking board.
6. Install the:
a. base cover
b. battery
7. Follow the procedure in After working inside your computer.
Graphics Processing Unit (GPU)
Removing the GPU board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
e. docking board
3. To remove the GPU board
a. Remove the screws that secure the GPU socket to the computer [1].
b. Lift the GPU socket from the board [2].
c. Remove the screws that secure the pull tab to the GPU board [3].
28
Disassembly and reassembly
To Next Page
Loading...
