Installing the system fan
1. Place the system fan into the slot on the computer chassis.
2. Tighten the screw to secure the system fan to the computer
3. Connect the system fan cable to the computer.
4. Route the system fan cable.
5. Install the:
a. base cover
b. optical drive
c. hard drive
d. battery
6. Follow the procedure in After working inside your computer.
RF cable holder
Removing the RF holder
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
e. GPS board
f. WLAN card
g. docking board
3. To remove the RF holder:
a. Unroute the antenna cables from the cable routing clips [1].
b. Remove the screw that secures the RF holder to the computer [2] .
c. Lift and remove the RF holder from the computer [3] .
Disassembly and reassembly
35
To Next Page
Loading...
