6. Slide the I/O board into its place on the computer.
7. Close the I/O bay press latch door.
8. Install:
a. base cover
b. optical drive
c. hard drive
d. battery
9. Follow the procedure in After working inside your computer.
Coin cell battery
Removing the coin cell battery
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To remove the coin cell battery:
a. Disconnect the coin cell battery cable [1].
b. Unroute the coin cell battery cable [2].
c. Lift the system coin cell away from the computer [3].
Installing the coin cell battery
1. Place the coin cell into the slot on the computer chassis.
2. Route the coin cell cable.
3. Connect the coin cell cable to the computer.
4. Install the:
a. base cover
b. optical drive
c. hard drive
d. battery
42
Disassembly and reassembly
To Next Page
Loading...
