Installing the WWAN card
1. Insert the WWAN card into the slot on the system board.
2. Tighten the screw to secure the WWAN card to the computer.
3. Connect the antenna cables to the WWAN card.
4. Install the:
a. base cover
b. optical drive
c. hard drive
d. battery
5. Follow the procedure in After working inside your computer.
GPS board
Removing the GPS board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To remove the GPS board:
a. Disconnect the antenna cable from the GPS board [1].
b. Disconnect the GPS board cable from the connector [2].
c. Remove the screw that secures the GPS board to the computer [3].
d. Lift the GPS board away from the computer [4].
32
Disassembly and reassembly
To Next Page
Loading...
