Installing the display
1. Connect the display cables to the connectors and fix the adhesive tapes.
2. Replace the display until it clicks in the display assembly.
3. Tighten the screws to secure the display to the display assembly.
4. Place the plastic tab to secure it in the display assembly.
5. Flip the display assembly.
6. Tighten the screws to secure the display to the display assembly.
7. Install the:
a. display assembly
b. base cover
c. optical drive
d. hard drive
e. battery
8. Follow the procedure in After working inside your computer.
Input-Output board
Removing the I/O board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To access the I/O board:
a. Release the latch door and remove the epoxy screws [1].
b. Peel the adhesive tape [2].
4. To release the I/O board:
a. Peel the adhesive tape [1].
40
Disassembly and reassembly
To Next Page
Loading...
