j. battery
4. Follow the procedure in After working inside your computer.
Camera
Removing the camera
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. display assembly
3. To remove the camera:
a. Peel the adhesive tape [1] and disconnect the camera cable from the camera module [2].
b. Remove the screws that secure the camera to the display panel [3].
c. Peel the adhesive tape [4].
d. Lift the camera away from the display [5].
Installing the camera
1. Place the camera on the camera module.
2. Affix the adhesive tape to secure the camera module.
3. Connect the camera cable to the connector.
4. Tighten the screws to secure the camera module to the display panel.
5. Affix the adhesive tape to the display.
6. Install the:
a. display assembly
b. battery
7. Follow the procedure in After working inside your computer.
Disassembly and reassembly
49
To Next Page
Loading...
