1. Align and replace the 3-cell battery into the computer chassis.
2. Route the battery cable through the routing channels between the system board and 3-cell battery.
3. Affix the adhesive tapes to secure the 3-cell battery to the computer chassis.
4. Place the two battery brackets into position at the bottom left and bottom right of the battery, ensuring they keep the 3-cell
battery secured into position.
5. Secure the two battery brackets into position with the two screws (M2x3). Be careful not to install the screws into the
screw holes at the top left and right sides of the battery:
6. Connect the battery cable to the system board.
1. Install the palmrest and keyboard assembly.
Removing and installing components
31
To Next Page
Loading...
