Image: Touch-panel assembly
installation
1. Align and place the touch-panel assembly on the display cover.
2. Connect the display cable to the connector on the touch-control board.
3. Affix the tape to secure the connector on the touch-control board.
4. Connect the display cable to the connector on the display panel.
5. Affix the rubber sticker on the display-cable connector.
6. Affix the mylar tape to secure the display cable on the rear of the display panel.
7. Gently snap the touch panel assembly into place.
1. Install the display assembly.
2. Install the palmrest and keyboard assembly.
3. Follow the procedure in after working inside your computer.
Display bezel (Laptop)
Removing the display bezel (Laptop)
NOTE: The following display bezel removal procedure is applicable to Latitude 3140 laptops only.
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
3. Remove the display assembly.
The following images indicate the location of the display bezel and provide a visual representation of the removal procedure.
Removing and installing components
65
To Next Page
Loading...
