Dell Latitude 3140 2 in 1 - World-Facing Camera (2-In-1)

1. Place the power-adapter port into the slot on the computer chassis.
2. Replace the two screws (M2x4) that secure the power-adapter port to the computer chassis.
3. Connect the power-adapter port cable to the connector on the system board.
1. Install the palmrest and keyboard assembly.
2. Follow the procedure in after working inside your computer.
World-facing camera (2-in-1)
Removing the world-facing camera (2-in-1)
NOTE: The following world-facing camera removal procedure is applicable to Latitude 3140 2-in-1 only.
CAUTION: This is a fragile component. Handle with care.
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
The following images indicate the location of the world-facing camera and provide a visual representation of the removal
procedure.
Removing and installing components
35