Dell Latitude 3140 2 in 1 - Page 36

1. Disconnect the world-facing camera cable from the connector on the camera module.
2. Remove the single screw (M2.5x2.5) that secures the world-facing camera module to the computer chassis.
3. Lift and remove the world-facing camera module from the computer chassis.
Installing the world-facing camera (2-in-1)
NOTE: The following world-facing camera installing procedure is applicable to Latitude 3140 2-in-1 only.
CAUTION: This is a fragile component. Handle with care.
The following image indicates the location of the world-facing camera and provides a visual representation of the installation
procedure.
36
Removing and installing components