1. Insert the world-facing camera module into the slot on the computer chassis.
2. Replace the single screw (M2.5x2.5) to secure the world-facing camera module to the computer chassis.
3. Connect the world-facing camera cable to the connector on the camera module.
1. Install the palmrest and keyboard assembly.
2. Follow the procedure in after working inside your computer.
Heat sink
Removing the heat-sink assembly
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
The following images indicate the location of the heat-sink assembly and provide a visual representation of the removal
procedure.
Removing and installing components
37
To Next Page
Loading...
