1. Place the coin cell battery into the slot on the computer chassis.
2. Connect the coin cell battery cable to the connector on the system board.
1. Install the palmrest and keyboard assembly.
2. Follow the procedure in after working inside your computer.
Audio board
Removing the audio board
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
3. Remove the speakers for laptops, or speakers for 2-in-1s.
The following image indicates the location of the audio board and provides a visual representation of the removal procedure.
1. Disconnect the audio-board cable from the connector on the system board.
2. Remove the two screws (M2x3) that secure the audio board to the computer chassis.
3. Lift and remove the audio board from the computer chassis.
Installing the audio board
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the audio board and provides a visual representation of the installation procedure.
Removing and installing components
27
To Next Page
Loading...
