2. Route the speaker cable through the routing channel.
3. Affix the adhesive tapes to secure the speaker cable on the system board.
4. Connect the speaker cable to the connector on the system board.
1. Install the palmrest and keyboard assembly.
2. Follow the procedure in after working inside your computer.
Removing the speakers (2-in-1)
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
1. Disconnect the speaker cable from the connector on the system board.
2. Remove the adhesive tapes that secure the speaker cable to the system board.
3. Unroute the speaker cable from the routing channel.
4. Lift and remove the speakers from their slots on the computer chassis.
Installing the speaker (2-in-1)
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
24
Removing and installing components
To Next Page
Loading...
