1. Disconnect the speaker cable from the connector on the system board.
2. Remove the adhesive tapes that secure the speaker cable to the system board.
3. Unroute the speaker cable from the routing channel.
4. Lift and remove the speakers from their slots on the computer chassis.
Installing the speaker (Laptop)
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
1. Using the alignment posts and rubber grommets, replace the speaker into the slots on the computer chassis.
Removing and installing components
23
To Next Page
Loading...
