1. If your computer has a USB-C port, remove the two screws (M2x4) that secure the USB-C bracket to the system board.
Lift and remove the USB-C bracket from the system board.
2. Remove the single screw (M2x3) that secures the display-cable bracket to the system board. Lift and remove the display-
cable bracket from the system board.
3. Disconnect the power-adapter port cable from the system board.
4. Open the latch and disconnect the display cable from the connector on the system board.
5. Remove the single screw (M2x3) that secures the WLAN antenna cable bracket to the system board.
Removing and installing components
41
To Next Page
Loading...
