Installing the speakers
1 Place the speakers into the slots on the computer.
2 Ax the adhesive tape to secure the speaker cable to the computer
3 Route the speaker cable through its routing channel.
4 Connect the speaker cable to the connector on the system board.
5 Install the:
a SSD
b battery
c base cover
6 Follow the procedure in After working inside your computer.
Coin cell battery
Removing the coincell battery
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the coin cell:
a Pry the coincell battery until it pops out from its slot [1].
b Lift and remove the coin cell from the system [2].
Removing and installing components
27
To Next Page
Loading...
