NOTE: Tighten the heat sink screws in sequential order as indicated on the heat-sink.
3 Install the:
a battery
b base cover
4 Follow the procedure in After working inside your computer.
System Fan
Removing the system fan
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the system fan:
a Unroute the eDP cable from the routing channel on the system fan [1]. Disconnect the system fan cable from its connector on
the system board [2].
b Remove the 3 M2.5x5 screws securing the fan to the palmrest [1] and then lift the fan o the computer [2].
30
Removing and installing components
To Next Page
Loading...
