Installing the system fan
1 Place the fan on the computer.
2 Tighten the 3 M2.5x5 screws to secure the fan to the computer.
3 Connect the fan cable to the system board.
4 Route the eDP cable through its routing channel on the system fan.
5 Install the:
a battery
b base cover
6 Follow the procedure in After working inside your computer.
Input-Output board
Removing the Input-Output board
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the Input-Output (I/O) board:
a Move aside the HDD cable to access the I/O board cable [1] and remove the I/O board cable from the connector on the system
board [2].
Removing and installing components
31
To Next Page
Loading...
