Installing the LCD Panel
1 Connect the LCD cable to its connector on the back side of the LCD panel.
2 Ax the adhesive sticker.
3 Place the LCD panel on the LCD back cover and align the LCD panel with the screw holders on the LCD back cover.
4 Replace the 4 M2x2 screws to secure the LCD panel to the LCD back cover.
5 Route the eDP cable through the routing channel and secure the cable to the display panel with an adhesive tape.
6 Install the:
a LCD bezel
b display assembly
c Installing the WWAN card
d Installing the WLAN card
e battery
f base cover
7 Follow the procedure in After working inside your computer
LCD Hinge
Removing the LCD hinge
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b WLAN card
c WWAN card
d display assembly
46
Removing and installing components
To Next Page
Loading...
