Installing the eDP and camera cable
1 Route the display cable through its routing channel and secure the display cable to the LCD back cover with the adhesive tapes.
2 Connect the camera cable to its connector on the LCD back cover.
3 Replace the screws to secure the right hinge bracket to the LCD back cover.
4 Secure the eDP cable to the LCD back cover with adhesive tapes.
5 Install the:
a LCD panel
b LCD bezel
c display assembly
d Installing the WWAN card
e Installing the WLAN card
f battery
g base cover
6 Follow the procedure in After working inside your computer
System board
Removing system board
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
c WLAN card
d WWAN card
Removing and installing components
49
To Next Page
Loading...
