a base cover
b WLAN card
c WWAN card
d display assembly
e LCD bezel
f LCD panel
3 Remove the adhesive tapes that secure the camera and the eDP cable [1].
4 Remove the screws securing the right bracket to the LCD back cover [2] and lift the bracket away from the LCD back cover [3].
5 Disconnect the camera cable from its connector on the LCD back cover [4].
6 Unroute the cable from the routing clips on the LCD back cover, release it from the adhesive tapes that secure the cable to back
cover.
48
Removing and installing components
To Next Page
Loading...
