DC-In Port
Removing the DC-in port
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b Removing the WLAN card
c Removing the WWAN card
d display assembly
3 To remove the DC-in port:
a Disconnect the DC-in cable from its connector on the system board [1].
b Unroute the DC-in cable from the routing clip on the system [2].
c Remove the M2.5x3 screw that secures the DC-in port to the palmrest [3].
d Lift the DC-in port from the system [4].
Installing the DC-in port
1 Place the DC-in port in its place on the palmrest.
2 Replace the M2x3 screw to secure the DC-in port to the palmrest.
3 Route the DC-in cable through the clip on the system.
4 Connect the DC-in cable to the connector on the system board.
5 Install the:
40
Removing and installing components
To Next Page
Loading...
