Dell Latitude E6410 - Camera Removal and Replacement

Back to Removing and Replacing Parts
Camera
Dell™Latitude™E6410/E6410ATGServiceManual
Removing the Camera
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery.
3. Remove the display bezel.
4. Loosen the captive screw that secures the camera to the computer.
5. Remove the camera from the slot on the computer.
6. Disconnect the data cable to remove the camera from the computer.
Replacing the Camera
To replace the camera, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.