Dell Latitude E6410 - Memory Module Removal and Replacement

Back to Removing and Replacing Parts
Memory
Dell™Latitude™E6410/E6410ATGServiceManual
Removing the Memory Module
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Remove the battery.
4. Remove the access panel.
5. Spread apart the securing clips on each end of the memory module connector until the memory module pops up.
6. Slide and remove the memory module out of the socket.
Replacing the Memory Module
To replace the memory module, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.