Dell Latitude E6410 - ExpressCard Removal and Replacement

Back to Removing and Replacing Parts
ExpressCard
Dell™Latitude™E6410/E6410ATGServiceManual
Removing the ExpressCard
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Press and release the card eject button.
4. Press the card eject button to release the card.
5. Remove the card out of the computer.
Replacing the ExpressCard
To replace the ExpressCard, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.