Dell Latitude E6410 - Smart Card Removal and Replacement

Back to Removing and Replacing Parts
Smart Card
Dell™Latitude™E6410/E6410ATGServiceManual
Removing the Smart Card
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Pull and remove the smart card out of the computer.
Replacing the Smart Card
To replace the smart card, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.