Dell Latitude E6410 - Keyboard Removal and Replacement

Back to Removing and Replacing Parts
Keyboard
Dell™Latitude™E6410/E6410ATGServiceManual
Removing the Keyboard
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG port cover (applicable on E6410 ATG computer only).
3. Remove the battery.
4. Remove the LED cover.
5. Remove the screws that secure the keyboard to the computer.
6. Use a plastic tab to lift the back edge of the keyboard to release the keyboard.
7. Slide the keyboard toward the back of the computer and remove the keyboard from the computer.
Replacing the Keyboard
To replace the keyboard, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.