Dell Latitude E6410 - Latitude ON Flash;CMG Module Removal and Replacement

Back to Removing and Replacing Parts
LatitudeON™Flash/CMGModule
Dell™Latitude™E6410/E6410ATGServiceManual
Removing the Latitude ON Flash/CMG Module
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG port cover (applicable on E6410 ATG computer only).
1.
4. Remove the left hinge cover. (See Removing Hinge Covers).
5. Remove the screw that secures the Latitude ON Flash/CMG module.
6. Remove the Latitude ON Flash/CMG module.
Replacing the Latitude ON Flash/CMG Module
To replace the Latitude ON Flash/CMG Module, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.
Remove the battery.