Dell Networking N4000 Series

To Next Page

To Previous Page

Starting and Configuring the Switch

First:

Step 1:

The system is not setup for SNMP management by

default. To manage the switch using SNMP (required for

Dell Network Manager) you can

. Set up the initial SNMP version 2 account now.

. Return later and setup other SNMP accounts. (For

more information on setting up an SNMP version 1

or 3 account, see the user documentation).

Would you like to setup the SNMP management interface

now? [Y/N] n

Step 2:

Now we need to setup your initial privilege (Level 15)

user account. This account is used to login to the CLI

and Web interface. You may setup other accounts and

change privilege levels later. For more information on

setting up user accounts and changing privilege

levels, see the user documentation.

To setup a user account:

Please enter the user name. [root]:

Please enter the user password:

Please reenter the user password:

Step 3:

Next, IP addresses are setup on the OOB (Out-Of-Band)

Interface and/or the VLAN1 routing interface.

You can use these IP addresses to access the CLI, Web

interface, or SNMP interface of the switch.

To access the switch through any Management Interface

you can

. Setup the IP address for the Management Interface.

Dell Networking N4000 Series - Page 27