Menu Item Description
NOTE: The default setting for In-System
Characterization is subject to change in
future BIOS releases.
When enabled, In-System Characterization (ISC)
executes during POST upon detecting relevant
change(s) in system configuration to optimize
system power and performance. ISC takes about
20 seconds to execute, and system reset is
required for ISC results to be applied. The Enabled
- No Reboot option executes ISC and continues
without applying ISC results until the next time
system reset occurs. The Enabled option executes
ISC and forces an immediate system reset so that
ISC results can be applied. It takes the system
longer to be ready due to the forced system reset.
When disabled, ISC does not execute.
About Boot Manager
Boot Manager enables you to add, delete, and arrange boot options. You can also access System Setup
and boot options without restarting the system.
Entering Boot Manager
The Boot Manager screen allows you to select boot options and diagnostic utilities.
1. Turn on or restart your system.
2. When the company logo is displayed, press F11. The Boot Manager page is displayed.
If your OS begins to load before you press F11, allow the system to finish booting, and then restart
your system and retry the operation.
Boot Manager main menu
Menu Item Description
Continue Normal Boot The system attempts to boot to devices starting
with the first item in the boot order. If the boot
attempt fails, the system continues with the next
item in the boot order until the boot is successful
or no more boot options are found.
One Shot Boot Menu Takes you to the boot menu where you can select
a one-time boot device to boot from.
Launch System Setup Enables you to open the System Setup page.
Launch Lifecycle Controller Exits the Boot Manager and invokes the Lifecycle
Controller program.
36
To Next Page
Loading...
