Figure 34. Removing and installing the NDC
1. captive screw socket (2) 2. connector on the system board
3. captive screw (2) 4. touch point (2)
5. NDC 6. back panel slots for Ethernet
connectors
Next steps
1. Replace the NDC. See Installing the NDC section in this document.
2. Complete the tasks listed in After working inside your system section in this document.
Installing NDC
Prerequisites
1. Ensure that you read the Safety instructions section in this document.
2. Complete the tasks listed in the Before working inside your system section in this document.
3. If applicable, remove the expansion card(s) in the expansion-card riser 2.
4. Keep the #1 Philips screwdriver handy.
85
To Next Page
Loading...
