Figure 33. Removing and installing the integrated storage controller card
1. integrated storage controller cable 2. integrated storage controller card
3. integrated storage-controller card
connector on the system board
4. integrated storage controller card
holder
Next steps
1. Replace the expansion-card riser 1.
2. Replace the cooling shroud.
3. Complete the tasks listed in the After working inside your system section in this document.
Installing integrated storage controller card
Prerequisites
1. Ensure that you read the Safety instructions section in this document.
2. Complete the tasks listed in the Before working inside your system section in this document.
3. Remove the cooling shroud.
4. Remove the expansion card riser 1.
5. Keep the #2 Phillips screwdriver handy.
83
To Next Page
Loading...
