3. Reconnect the system to its electrical outlet and peripherals.
4. Turn the system on, including any attached peripherals.
Recommended tools
You need the following tools to perform the removal and installation procedures:
• Key to the bezel lock. This is only required when you have a bezel.
• #2 Phillips screwdriver
• #1 Phillips screwdriver
• T6, T8, T10, and T15 Torx screwdrivers
The following tools are required for assembling cables for a DC PSU.
• AMP 90871-1 hand-crimping tool or equivalent
• Tyco Electronics 58433-3 or equivalent
• Wire-stripper pliers capable of removing insulation from size 10 AWG solid or stranded, insulated
copper wire
NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).
Front bezel (optional)
Removing front bezel
1. Unlock the bezel lock at the left end of the bezel.
2. Lift the release latch next to the bezel lock.
3. Pull the left end of the bezel, unhook the right end, and remove the bezel.
42
To Next Page
Loading...
