Dell NX3230 - Page 9

Item Indicator, Button, or
Connector
Icon Description
To reset the iDRAC (if not disabled on the iDRAC
Setup page by pressing F2) press and hold the
button for more than 15 seconds.
3 Turn on indicator, power
button
The turn on indicator glows when the system is
turn on. The power button controls the power
supply unit (PSU) output to the system.
NOTE: On ACPI-compliant operating systems,
turning off the system using the power button
causes the system to perform a graceful
shutdown before power to the system is
turned off.
4 NMI button Used to troubleshoot software and device driver
errors when running certain OSs. This button can
be pressed using the end of a paper clip.
Use this button only if directed to do so by
qualified support personnel or by the OSs
documentation.
5 Information tag A slide-out label panel that allows you to record
system information such as Service Tag, NIC, MAC
address, and so on as per your need.
6 HDDs Up to twelve 3.5-inch hot-swappable HDDs.
7 USB management port/
iDRAC Direct
Allows you to connect USB drives to the system or
provides access to the iDRAC Direct features. For
more information, see the Integrated Dell Remote
Access Controller User’s Guide at dell.com/
esmmanuals. The USB management port is USB
2.0-compliant.
NOTE: If the system is connected to a power
source and an issue is detected, the LCD
glows amber regardless of whether the
system is turned on or turned off.
8 iDRAC Direct LED
indicator
The indicator glows up to display issue status.
9 Video connector Allows you to connect a VGA display to the
system.
10 Quick Sync (optional)
NOTE: By default, Quick Sync option is not
available for Dell Storage NX3230 system.
Indicates a Quick Sync-enabled system. The Quick
Sync feature is optional and requires a Quick Sync
bezel. This feature allows management of the
system by using mobile devices. This feature
aggregates hardware or firmware inventory and
9