Steps
1. Place the tabs on the right side of the hard-drive bracket onto the holders on the chassis and push the left side of the
bracket down until it clicks into place.
NOTE: Use the arrows seen on the bracket as guides to identify the tabs on the tray.
2. Connect the hard-drive data and power cables to the connectors on the hard drive.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
3.5-inch hard drive
Removing the 3.5-inch hard-drive assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
20
Removing and installing components
To Next Page
Loading...
