NOTE: After releasing the Optical drive, you can also ip the drive assembly for easy access to the drive
cables.
NOTE: The Optical drive cables are available on side of the drive assembly.
5 To remove the optical drive:
a Slide the tab to release the optical drive [1].
b Push the optical drive away from the assembly [2][3].
Installing optical drive
1 Slide the optical drive into the optical drive assembly.
2 Align the tabs on the optical assembly with the slots on the computer.
3 Lower the optical drive assembly into the computer.
4 Lock the latch to secure the optical drive to the computer.
5 Connect the data and the power cables to the optical drive.
6 Install the:
a 2.5 inch hard drive assembly
22
Disassembly and reassembly
To Next Page
Loading...
