VGA Daughterboard
Removing the VGA daughter board
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the:
a Back Cover
b Bezel
3 Open the Front Bezel Door
4 To remove the VGA daughter board:
a Remove the screws that secure the VGA connector to the computer [1].
b Slide the VGA connector to release it from the computer [2].
c Remove the screw that secures the VGA daughter board to the computer [3].
d Lift the VGA daughter board using the handle to remove it from the computer [4].
Installing the VGA daughter board
1 Align the VGA daughter board with the screw holder on the system board.
2 Tighten the screw to secure the VGA daughter board to the system board.
3 Insert the VGA connector into the slot at the back of the computer.
4 Tighten the screws to secure the VGA connector to the computer.
5 Install the:
a Bezel
b Cover
6 Follow the procedure in After Working Inside Your Computer.
SD card
Removing SD card reader
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a cover
b front bezel
c 2.5 inch hard drive assembly
d cooling shroud
e optical drive
f M.2 PCIe SSD
3 To remove the SD card reader:
a Release the power cables from the retention clips on the SD card reader enclosure [1].
b Remove the 6 screws that secure the SD card reader [2].
c Lift the SD card reader away from the computer [3].
Disassembly and reassembly
29
To Next Page
Loading...
