Installing M.2 PCIe SSD
1 Insert the M.2 PCIe SSD to the connector
2 Press the blue plastic tab to secure the M.2 PCIe SSD.
3 Install the:
a optical drive
b cooling shroud
c 2.5 inch hard drive assembly
d front bezel
e cover
4 Follow the procedure in After working inside your computer.
Heat sink assembly
Removing heat sink assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a cover
b front bezel
c 2.5 inch hard drive assembly
d cooling shroud
e optical drive
3 To remove the heat sink assembly:
a Disconnect the heat sink assembly cable from the connector on the system board [1].
b Loosen the 6 captive screws that secure the heat sink assembly to the system board [2].
NOTE
: Loosen the screws based on the numbers available on the system board.
c Lift the heat sink assembly away from the computer [3].
24
Disassembly and reassembly
To Next Page
Loading...
