2. Press <Clrl> + <Alt> + <T> The interface appears as shown in the screenshot
below:
3. Type in the CROSH command for diagnostics. Type 'help' for a list of available commands. Type help_advanced to display
a complete list of commands for debugging purposes
Alternately, refer to CROSH Commands for the list of the CROSH commands available for diagnostics.
CROSH commands
The table below lists the available commands in Chrome Shell (CROSH).
Table 11. Help commands
Command Purpose
exit
Exits the CROSH Shell.
help
Displays this help.
help_advanced
Displays the help for more advanced commands, used for
debugging.
ping
[-c count] [-i interval] [-n] [-s packetsize] [-W waittime] —
Sends ICMP ECHO_REQUEST packets to a network host. If
is "gw", then the next hop gateway for the default route is
used. It works just like the ping command on other operating
systems. Press <Clrt> + <C> to stop the ping process or halt
any other command in CROSH.
ssh
[optional args...] — Starts the ssh subsystem if invoked
without any arguments. "ssh <user> <host>", "ssh
<user> <host> <port>", "ssh< user>@<host>". or "ssh
<user>@<host> <port>" connect without entering the
subsystem
ssh_forget_host
Removes a host from the list of known ssh hosts. This
command displays a menu of known hosts and prompts for
the host to forget.
top
Sets the chaps debug logging level. No arguments start
verbose logging
Table 12. Advanced help command
Command Purpose
battery_test[<test length>] Tests the battery discharge rate for a given number of
seconds. No argument defaults to a 300 s test.
Diagnostic and troubleshooting 41
To Next Page
Loading...
Need help?
General
